multi fuller expert glaze 440ml pack of 4

Description

Highest quality fast drying finishing polyester putty for car body repairs. Can be used as filling as well as finishing putty. Thanks to self-smoothing effect and low density can be also applied on large surfaces. Short hardening time and very easy sanding makes this putty ideal for short body car repairs – ‘fast repair’.

Advantages

• Ready to sand extremely quickly.
• Very easy application- self-smoothing effect.
• Low density.
• Easy to sand.
• Great adhesion to zinc coated steel and aluminium.
• 95% reduced shrinkage comparing to standard products.

Substrates

• The product has very good adhesion to various substrates. It can be applied over:
• Black and zinc coated steel and aluminium after flatting and degreasing.
• Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing coatings in good condition.
• Caution: Do not apply the putty directly on the reactive primers, 1K acrylic and nitrocellulose products.

Use for

Very light polyester putty for fast car repairs.

Attention

Crumple the bag several times, before use, to obtain a homogeneous consistency, than squeeze the putty through the hole.

Mixing ratio by weight

Putty: 100

Hardener: 2

Stir thoroughly until achieving homogenous paste to not create air inclusions.

Layer thickness

Putty can be applied in several thin layers. Before application of the next layer, the previous one must be cured. Do not exceed the thickness of 4 mm.

Pot life is 4÷6 minutes at 20°C

Hardening time

16÷20 minutes at 20°C.

Temperature below 20°C significantly increases the hardening time.

• Sanding
• Coarse sanding (dry): P100-P180,
• Finishing sanding (dry): P180-P320.

IR Drying

• 5÷7 minutes of short waves, depending on the layer thickness and the type of radiator.
• Do not exceed the temperature of 60°C.
• Use as recommended by the equipment manufacturer.
• Caution: Wait about 5 minutes before the IR drying process.

Further work

• Polyester putties can be over coated with:
• 2K polyester putties
• 2K polyester spray fillers.
• 2K wash primers.
• 2K epoxy fillers
• 2K acrylic fillers.

General notes

• Excessive amount of hardener will cause problems with bleaching of the top coat!
• The rooms should be well ventilated.
• Tools should be washed directly after application.
• Use personal protection equipment during the 2K products application. Protect
• the eyes and respiratory system.

Caution: To maintain safety, always follow the instructions given in the MSDS for the products.